威海叉車的日常維護

一、叉車剎車片
forklift brake pad
叉車剎車片呈現磨損，在正常的叉車駕馭行車中，靠感覺是感覺不出來的。有些能夠直接查看，但有些車型需求拆開出來才干看到。正常的剎車片有9毫米厚，當磨到2-3毫米時就必須換了；等全磨破顯露剎車片附著的金屬片，這樣就會呈現金屬與金屬沖突的異響。梯諾機械表明替換剎車片時一般修理工都是讓一切有相關的叉車配件都一同換掉，正常狀況下都是能夠單換的，如：僅僅單剎車分泵漏油，換了剎車分泵后剎車片能夠清洗潔凈剎車片和剎車輪轂，假如是剎車片磨損的話剎車輪轂沒磨損，只換剎車片就能夠了，別的配件就清洗潔凈，軸承方位再從頭增加新的黃油即可，悉數安裝好后再調 下剎車片和剎車輪轂之間的空隙就能夠正常運用了。
the forklift brake pad is worn out, and it can not feel out of the normal forklift driving. some can directly view, but some models need to be opened up to see. normal brake pads are 9 mm thick and must be replaced when they are ground to 2-3 mm. when the metal pads attached to the brake pads are completely worn out, the abnormal sound of metal-metal conflict will appear. tino machinery shows that when replacing brake pads, the general repairman replaces all relevant forklift parts together. normally, they can be replaced separately. for example, only the single brake pump leaks oil, the brake pads after replacing the brake pump can clean the brake pads and the brake wheel hub, if the brake pads wear out, the brake wheels can be cleaned. if the hub is not worn out, just change the brake pads, the other parts will be cleaned and cleaned, and the bearing orientation can be added with new butter from scratch. after all installation, the gap between the brake pads and the hub of the brake wheel can be adjusted to normal use.
二、叉車火花塞
two. forklift spark plug
叉車火花塞是在修理時有許多的修理商都會勸叉車用戶提早替換的小配件，但實際上假如駕馭員在用車時沒感覺到有點火不良、加快不力、沒有放炮等缺點現象的話就能夠不替換。但是定時要拆出來查看是有必要的，但假如火花塞確實壞了就一定要及時替換，有些車型壞了的火花塞還會呈現掉落掉在發動機的汽缸里面，這樣就會引發更大的叉車缺點。
forklift spark plug is a small part that many repairmen will advise forklift users to replace earlier, but in fact, if the driver does not feel a little bad fire, slow speed, no artillery and other shortcomings when using the vehicle, he can not replace it. but it is necessary to take it out regularly, but if the spark plug does break down, it must be replaced in time. some of the broken spark plugs will fall into the engine cylinder, which will lead to greater shortcomings of forklift trucks.
三、叉車剎車油
three. forklift brake oil
正常狀況下修理工一般要求1年左右即進行替換，但實際沒太大缺點，假如叉車制動體系配件未呈現異常就不必替換。但需常常查看有沒有短少或許變質或許也能夠通過目測，假如剎車油低于低液面就真的需求換或許直接增加了。叉車剎車油假如嚴峻短少會影響到剎車的制動功能，在替換叉車剎車油必需要換正品的，不是正品的用久了后會形成整套剎車體系會失靈。梯諾機械表明關于剎車油是否正品的檢測方法能夠用以下這個方法：伸個手指進到剎車油瓶內，泡到剎車油后然后伸出來在正?？諝庵幸环昼娮笥沂种赣邪l熱的感覺，根本能夠判別為這款叉車剎車油為正品。
under normal conditions, repairmen usually require replacement within one year or so, but there are not too many shortcomings in practice. if the brake system accessories of forklift truck do not show abnormalities, it is not necessary to replace them. however, it is often necessary to check whether there is any shortage or deterioration, or to be able to pass visual inspection. if the brake oil is below the minimum level, the real demand may increase directly. forklift brake oil, if severe, will affect the braking function of the brake. in order to replace the brake oil of the forklift, it is necessary to replace the genuine brake oil. if not the genuine brake oil is used for a long time, the whole brake system will fail. tino machinery shows that the detection method of whether the brake oil is genuine can use the following method: stretch one finger into the brake oil bottle, soak into the brake oil, and then stretch out in normal air for about a minute, the finger has a fever feeling, can basically distinguish the forklift brake oil as genuine.
四、叉車機油
four. forklift oil
一些進口的機油正常狀況下是在1500小時進行替換，而國產的機油一般是在750個小時左右就必需要替換。但實際上只要油色明澈、油面不低于標明的低液面，沒有特殊狀況下機油的替換也不必那么頻頻。運用頻頻的叉車（一天操作超越十個小時以上）能夠一個月左右替換，運用需求一般的叉車（一天操作在正常的八小時內）能夠三個月左右保養一次，而運用較少的叉車（一天操作不超越三小時的）主張要半年保養一次，要不會形成發動機容易磨損和光滑欠好的狀況，機油必須挑選正品的來運用。
some imported oil is normally replaced in 1500 hours, while domestic oil is usually replaced in 750 hours or so. but in fact, as long as the oil color is clear and the oil level is not lower than the lowest level indicated, the replacement of oil does not have t